Sandblasting operation processing
naky
www.diecastingpartsupplier.com
2014-12-05 17:23:39
Sandblasting operation processing
1, the first open lights, after opening the compressed air valves, air spray nozzle 2 to 5 minutes , so that the pipe in the water spray out , so as not to wet sand and then shutting the valve will lose sand compressed air tube into the sand .
2 , and then into the working parts inside ( small pieces can be fitted with a basket ) , shut the door .
3, then start ventilation equipment , air valve open , blasting . When sandblasting nozzle should be tilted 30 ° ~ 40 °; should be evenly rotated or flipped back and forth slowly moving parts and parts or nozzles , so that parts of the surface subjected to a uniform jet , silver gray until the whole surface of the part so far. ( For the basket to hold small parts, parts jitter flip straight to reach blasting requirements . )
4 , where the parts have precision or finish requirements , you can not blast . If there are local requirements should not blast site on the same part , can only after blasting should be protected.
5 , each batch of parts after spraying , immediately shutting compressed air valve , and then unpack parts.
6, after the general parts sand , handed down procedure, as anti-rust treatment . But matt chrome parts , sandblasting plating treatment immediately after passing .
7 , only requires a cast iron hair spray blasting , sandblasting rust treatment is not performed immediately after passing the post processing plant .
1, the first open lights, after opening the compressed air valves, air spray nozzle 2 to 5 minutes , so that the pipe in the water spray out , so as not to wet sand and then shutting the valve will lose sand compressed air tube into the sand .
2 , and then into the working parts inside ( small pieces can be fitted with a basket ) , shut the door .
3, then start ventilation equipment , air valve open , blasting . When sandblasting nozzle should be tilted 30 ° ~ 40 °; should be evenly rotated or flipped back and forth slowly moving parts and parts or nozzles , so that parts of the surface subjected to a uniform jet , silver gray until the whole surface of the part so far. ( For the basket to hold small parts, parts jitter flip straight to reach blasting requirements . )
4 , where the parts have precision or finish requirements , you can not blast . If there are local requirements should not blast site on the same part , can only after blasting should be protected.
5 , each batch of parts after spraying , immediately shutting compressed air valve , and then unpack parts.
6, after the general parts sand , handed down procedure, as anti-rust treatment . But matt chrome parts , sandblasting plating treatment immediately after passing .
7 , only requires a cast iron hair spray blasting , sandblasting rust treatment is not performed immediately after passing the post processing plant .
Предыдущий : Пескоструйная препараты