Home > News > Industry News > Injection molding is a profess.....
Certifications
Contact us
Vice General Manager: Ivy
Tel:86-13312953695
Tel:86-755-82737317/82737469
Fax:86-755-82737710
E-mail: sales.china@xy-global.com
Postal Code: 518109
Off Add: Room 405, LiJinCheng Bulding, Jihua Road, Longhua new district,Shenzhen.
Factory Add:Daling Industrial Area,Shaling,Fenggang Town,Dongguan CityContact Now

News

Injection molding is a professional technology for Manufacturers

  • Author:diecastingpartsupplier
  • Source:www.diecastingpartsupplier.com
  • Release on :2017-04-14
  Injection molding necessitates uniform wall thickness. If you were to cut a cross-section of the Panasonic mold above you would notice that the wall thickness is approximately 2-3mm thick throughout. Keeping walls from being too thick is important to prevent inconsistencies in the cooling process resulting in defects like sink marks. A good rule of thumb is to keep walls less than or equal to 4mm thick. The thicker the walls the more material you will use, the longer the cycle time will be and the higher your cost per part will be.

  Conversely, if wall thickness is any thinner than 1mm or so you might experience trouble filling the mold tool (resulting in gaps or short shots). Designers can compensate for this potentiality by using a material with a higher melt flow index like Nylon which is often suitable for walls as thin as 0.5mm. Different injection mold design Suppliers techniques like CNC don’t require uniform wall thickness at all.